Mp#0-We got the robot set up to pull parts. Ran a few shots and realized the bottom core block was not releasing correctly. Found that the mold was missing the horn pins for the slide. They were broken and nowhere to be found. We pulled the front and tooling made some new ones. Then we started it up running on the robot at approximately 5 a.m.
Mp#24- The material loader suction motor wore out. I broke it down and found the brushes worn out and the commutator was so worn that entire motor replacement will be required. There wasnt one in stock so we need to order one asap unless there may be one at algood whse.?
MP#4- Nozzle band had bleed off. Had to replace the tip band and thermocouple.
Also looked at the mitsubishi PLCs in the pad printers. They all have the Melsec plcs model FX1n. We should use the GX-Programmer software or more current. Programming cables are about 25$.
No comments:
Post a Comment