The past week has had our team busy in many areas one of which has been working with the hot stamp roller machines. All of which have needed extensive attention to get into reliable operating condition.
NOTES
A few notes I wanted to make are on the temperature controllers they utilize. It is important to understand that the outputs must be allocated upon set up so that the SSD and Relay contacts are configured correctly ro work with the PLC controls.
Also be awarevthat the PLC will interupt the heat controls if the temperature controller settings are not correct in this application.
One way to verify this is to compare settings from another machine within the first three levels.
Also remember that to move up or down levels - "levl" must be flashing after the ↑↓ buttons have been held down for three seconds.
No comments:
Post a Comment